myWerkzeug.de › CNC.myWerkzeug.de › Templates › Games
CNC template · Games
Fishing game with magnetic rods
Ten fish with points and eyes, a round pond as playing area and two rods. A washer in each fish's mouth and a magnet on the line, and they bite. For small hands, from three years.
- Size
- 376 × 568 mm, 6 mm thick
- Material
- Plywood
- Difficulty
- Beginner
- Milling time
- approx. 32 min
- Bits
- V-bit 60°, End mill Ø 2 mm, End mill Ø 3.175 mm
- Customise
- Size, text and details adjustable with sliders
- With a laser
- diode laser from about 10 W (cuts 6 mm)
Try it without an account · carve with Chrome or Edge · no installation
Build instructions
Materials and accessories
| Qty | Part |
|---|---|
| 1 | Neodymium disc magnets and two-component adhesive |
| 1 | Wood paints or acrylic paints |
| 1 | Nylon thread or yarn |
Also: sandpaper (grit 120 and 240), a utility knife or fine saw and, for joints, a rubber mallet.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Engrave points, gills and waves, mill eyes and holes, then cut out fish, pond and rods.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Lightly break the edges with sandpaper (grit 120, then 240) and remove burrs.
Assembly and final touches
- Glue an M5 washer into each fish's mouth. Tie a 40 cm line to each rod with a magnet with eyelet at the end.
- Paint the fish and put them in the pond; whoever catches the most points wins. Magnets do not belong in children's hands without supervision: glue them firmly and check regularly.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
