myWerkzeug.de › CNC.myWerkzeug.de › Templates › Kitchen
CNC template · Kitchen
Breakfast board for eggs
Solid board with hollows for boiled eggs, a hollow for salt and an engraved greeting. For the breakfast table or Easter brunch; number of eggs and text adjustable.
- Size
- 258 × 178 mm, 18 mm thick
- Material
- Hardwood (beech, oak)
- Difficulty
- Beginner
- Milling time
- approx. 17 min
- Bits
- End mill Ø 6 mm, V-bit 60°, End mill Ø 6 mm
- Customise
- Size, text and details adjustable with sliders
- With a laser
- milling machine only (deep pockets)
Try it without an account · carve with Chrome or Edge · no installation
Build instructions
Materials and accessories
| Qty | Part |
|---|---|
| 1 | Wood oil, wax or clear varnish |
Also: sandpaper (grit 120 and 240), a utility knife or fine saw and, for joints, a rubber mallet.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Clear the hollows with the 6 mm end mill, engrave the greeting, finally cut out the outline.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Round the edges of the hollows with sandpaper wrapped around a finger.
Assembly and final touches
- Only treat with food-safe oil (such as linseed or walnut oil) and polish once dry. Not dishwasher safe.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
