A name in script lettering, cut out and joined by a bar at the bottom, with two eyelets for hanging. For a nursery, a door or as a gift.
- Size
- 242 × 101 mm, 4 mm thick
- Material
- Plywood
- Difficulty
- Beginner
- Milling time
- approx. 10 min
- Bits
- End mill Ø 2 mm
- Customise
- Size, text and details adjustable with sliders
- With a laser
- diode laser from about 6 W (cuts 4 mm)
Try it without an account · carve with Chrome or Edge · no installation
Build instructions
Materials and accessories
| Qty | Part |
|---|---|
| 1 | Wood paints or acrylic paints |
Also: sandpaper (grit 120 and 240), a utility knife or fine saw and, for joints, a rubber mallet.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- First carve the counters of the letters and the eyelets, then the outline with the 2 mm end mill.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Lightly break the edges with sandpaper (grit 120, then 240) and remove burrs.
Assembly and final touches
- Paint or varnish as you like. To hang it, thread a cord through the eyelets or use two nails.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
