myWerkzeug.de › CNC.myWerkzeug.de › Templates › Workshop
CNC template · Workshop
Slot-together drawer insert
Grid of half-lapped strips that divides any drawer into compartments: enter the inside size of the drawer, choose columns and rows, done. No glue, can be rearranged at any time.
- Size
- 315 × 240 mm, 4 mm thick
- Material
- Plywood
- Difficulty
- Beginner
- Milling time
- approx. 13 min
- Bits
- End mill Ø 3.175 mm
- Customise
- Size, text and details adjustable with sliders
- With a laser
- diode laser from about 6 W (cuts 4 mm)
Try it without an account · carve with Chrome or Edge · no installation
Build instructions
Apart from the workpiece you need nothing else.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Cut out all strips with their slots; the round bulges at the bottom of each slot are reliefs for the square mating strip.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Before gluing, dry-fit everything. If a joint is too tight, increase the clearance by 0.05 mm and carve the part again; if it wobbles, reduce it.
Assembly and final touches
- Push the cross strips, slots down, over the long strips until both are flush on top. Put the grid into the drawer; it holds without glue.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
