myWerkzeug.de › CNC.myWerkzeug.de › Templates › Kitchen
CNC template · Kitchen
Tablet and cookbook stand
Stand made of two side cheeks and two cross braces, slotted together without screws. Holds a tablet, phone or cookbook at an angle; spacing, ledge and fit adjustable.
- Size
- 264 × 226 mm, 6 mm thick
- Material
- Plywood
- Difficulty
- Intermediate
- Milling time
- approx. 12 min
- Bits
- End mill Ø 3.175 mm
- Customise
- Size, text and details adjustable with sliders
- With a laser
- diode laser from about 10 W (cuts 6 mm)
Try it without an account · carve with Chrome or Edge · no installation
Build instructions
Apart from the workpiece you need nothing else.
Carving and finishing
- Clamp the workpiece flat on the spoilboard or secure it with double-sided tape, and set the origin as shown in the carving assistant.
- Carve the mortises of the side cheeks first, then all outlines.
- Free the parts at the holding tabs with a utility knife or fine saw and sand the tab remains flush.
- Before gluing, dry-fit everything. If a joint is too tight, increase the clearance by 0.05 mm and carve the part again; if it wobbles, reduce it.
Assembly and final touches
- Push the tenons of both braces through the mortises of one side cheek, then fit the second cheek. The ledge points forward, the slope backward.
- If the stand is too loose, put a drop of glue into the mortises. For heavy cookbooks set a deeper ledge.
- Finally oil, wax or varnish; for toys use oils or varnishes that are saliva-resistant according to EN 71-3.
How to carve this template
- OpenOpen the template in the app and adjust size and text if you like.
- CheckLook at it in 3D, check run time and warnings.
- Set upThe carve wizard guides you through material, clamping, bit and zero point.
- CarvePress start; the app drives your Grbl router directly over USB.
